Your Shopping Basket
Your basket is empty.
On Sale
-
120 Cubic Foot Mid Pressure Faber Cylinder
Save $120.01 -
40# Mach V Oxycheq Wing - Black
Save $70.01 -
30# Mach V OxyCheq Wing - Black
Save $68.00 -
18# Mach V OxyCheq Wing
Save $67.99 -
2 Liter (12cuft) Faber Low Pressure Cylinder
Save $53.96 -
3 Liter 19 Cubic Foot Faber Tank
Save $37.00 -
4 Liter 27 Cubic Foot Faber Cylinder
Save $20.00 -
Din to Yoke Fill Adapter
Save $10.00 -
Raider I - II Light Sock
Save $5.21 -
Tribolube 71 Oxygen Compatible Lubricant
Save $5.20
Drysuit Hoses
Drysuit Hoses
Standard Connector
Machined Brass Ends
Northeast Scuba Supply, Inc. has these hoses made by a vendor. Instead of the rounded style or small knurled versions, these have a large brass end that has a distinctive edge to make it easier to grab with gloves. Our in stock inventory is available in 2 inch increments. If you do not see the length you are looking for please contact us as we can special order them.
Important Note: These are the standard connector drysuit hoses. They will fit many brands to determine if your drysuit has a standard connector, try hooking your BC hose into it. If it goes in than yours is a standard connector.
Johns Words of Wisdom: Hose is leaking.
There are four parts on a Drysuit hose that can fail below is listed the problem and remedies
1. Leaking from Rubber material
(Order new hose)
2. Leaking from Crimp Area –
(Order Hose) – in a pinch at a dive site you can clamp the crimp with a pair of pliers and it will usually stop the leaking. This is only temporary to get you and your buddy back in the water
3. Leaking from Quick Connect End (not hooked to power inflator)
This is a worn or corroded Schrader valve. These are the same Schrader valves in tires. Replace the Schrader valve with a new one and you are back in business.
4. Leaking from QD when attached to Power Inflator
This is a bad o-ring on inside of the quick disconnect. Just take a pick with a hook end and yank that sucker out of there. The o-ring replacement size is 011. Just lube a new one up and push it into the grove. This is harder than it sounds.
5. O-rings needed for repairs
011 on first stage
011 on QD Side